ALL PRODUCTS

SN:2000mm Digital ultrasonic sensor

The principle of ultrasonic distance measurement is to emit sound waves through an ultrasonic transmitter, and when the sound waves encounter obstacles, they return. The distance between the transmitter and the obstacle is calculated based on the conduction velocity and return time of the sound waves. This is the time difference distance measurement method. Ultrasonic waves are also a type of sound wave, and their propagation speed is related to factors such as temperature and pressure, but the influence of temperature can be ignored when the temperature changes little. If there is a high requirement for distance measurement, temperature compensation should be used for calibration

Overview
Related Products

Product model	UBX200-GM30-V4-H5	UBX400-GM30-V4-H5	UBX600-GM30-V4-H5	UBX800-GM30-V4-H5
	UBX200-GM30-V5-H5	UBX400-GM30-V5-H5	UBX600-GM30-V5-H5	UBX800-GM30-V5-H5
	UBX200-GM30-V6-H5	UBX400-GM30-V6-H5	UBX600-GM30-V6-H5	UBX800-GM30-V6-H5
	UBX200-GM30-V7-H5	UBX400-GM30-V7-H5	UBX600-GM30-V7-H5	UBX800-GM30-V7-H5
	UBX200-GM30-VI-H5	UBX400-GM30-VI-H5	UBX600-GM30-VI-H5	UBX800-GM30-VI-H5
	UBX200-GM30-VU-H5	UBX400-GM30-VU-H5	UBX600-GM30-VU-H5	UBX800-GM30-VU-H5
Detection range	80 ... 2000 mm	200 ... 4000 mm	350 ... 6000 mm	400 ... 8000 mm
Non-detection zone	0 ... 80 mm	0 ... 200 mm	0 ... 350 mm	0 ... 400 mm
Transducer frequency	approx. 180 kHz	approx. 85 kHz	About 65KHz	About 65KHz
response time	About 195 ms	145 ms minimum 440 ms factory setting	285 ms minimum 850 ms factory setting	285 ms minimum 850 ms factory setting
Standard target version	max. 30 Hz	max. 13 Hz	max. 7 Hz	max. 7 Hz
type of output	V4 :NPN normally open/normally closed V6：2 switch outputs PNP, NO/NC, VI:4-20mA
	V5：PNP normally open/normally closed V7：2 switch outputs NPN, NO/NC, VU:0-10V
working voltage	10-30V DC ripple 10%
Rated working current	200mA Passage/overload protection		2 x 100 mA , short- circuit/overload protected
Repetition accuracy of	≤ 0.5%		≤ 0.1%
Range adjustment	Adjust the farthest and nearest range through the adjusting line
Degree of protection	IP65
Connection mode	Connector plug M12 x 1 , 5-pin/2m PVC cable
LED yellow light	The yellow light of the switch status indicator flashes. The target is detected under the set status
LED red light	The red light is always on: error Red light flashing: no target is detected in the set state