BPS series Visible red light Connector Type

M12 connector type, The sensor has visible red light, making it easier to adjust.

Model	NPN Output	BPS-RO15M	BPS-RO10M	BPS-LO5M	BPS-LO3M	BPS-DO10
	PNP Output	BPS-RR15M	BPS-RR10M	BPS-LR5M	BPS-LR3M	BPS-DR10
Sensing method		Through-beam		Retro-Reflection		Diffuse Reflection
Sensing Range		15M	10M	5M	3M	100mm
Sensing target		Opaque materials, translucent materials
Hysteresis		≤20% of Sensing Range
Response time		Max. 1ms
Sensitivity adjustment		YES (Adjuster)
Operation mode		Light ON mode - Dark ON mode selectable (Control wire)
Indicator		Visible red light
Power supply		12-24 VDC ±10%(ripple P-P: 10%)
Current consumption		≤45mA
Control output		NPN open collector output / PNP open collector output model
Load voltage		≤30V DC
Load current		≤200mA
Residual voltage		NPN:1VDC , PNP:2.5 VDC
Protection circuit		Reverse power protection circuit, output short overcurrent protection circuit
Insulation resistance		≤20 MΩ(500 VDC megger)
Noise immunity		± 240 VDC the square wave noise (pulse width: 1 μs) by the noise simulator
Dielectric strength		1,000 VAC~ 50/60 Hz for 1 min
Vibration		1.5 mm double amplitude at frequency of 10 to 55 Hz (for 1 min) in each X, Y Zdirection for 2 hours
Ambient illuminance (receiver)		Sunlight:≤11,000 lx, incandescent lamp: ≤3,000 lx
Ambient temperature		-10 to 60 ℃, storage: -25 to 75 ℃ (no freezing or condensation)
Ambient humidity		35 to 85 %RH, storage: 35 to 85 %RH (no freezing or condensation)
Protection rating		IP67
Connection		connector type
Cable spec.		M12 connector 4PIN
Material		Case: Brass, Ni-plate
		Sensing part: PC lens