| Model | NPN Output | BPS-QO15M | BPS-QO10M | BPS-KO5M | BPS-CO3M | BPS-CO30 | BPS-CO10 |
| PNP Output | BPS-QR15M | BPS-QR10M | BPS-KR5M | BPS-CR3M | BPS-CR30 | BPS-CR10 |
| Sensing method | Through-beam | Retro-Reflection | Diffuse Reflection |
| Sensing Range | 15M | 10M | 5M | 3M | 300mm | 100mm |
| Sensing target | Opaque materials, translucent materials |
| Hysteresis | ≤20% of Sensing Range |
| Response time | Max. 1ms |
| Sensitivity adjustment | YES (Adjuster) |
| Operation mode | Light ON mode - Dark ON mode selectable (Control wire) |
| Indicator | Visible red light |
| Power supply | 12-24 VDC ±10%(ripple P-P: 10%) |
| Current consumption | ≤45mA |
| Control output | NPN open collector output / PNP open collector output model |
| Load voltage | ≤30V DC |
| Load current | ≤200mA |
| Residual voltage | NPN:1VDC , PNP:2.5 VDC |
| Protection circuit | Reverse power protection circuit, output short overcurrent protection circuit |
| Insulation resistance | ≤20 MΩ(500 VDC megger) |
| Noise immunity | ± 240 VDC the square wave noise (pulse width: 1 μs) by the noise simulator |
| Dielectric strength | 1,000 VAC~ 50/60 Hz for 1 min |
| Vibration | 1.5 mm double amplitude at frequency of 10 to 55 Hz (for 1 min) in each X, Y Zdirection for 2 hours |
| Ambient illuminance (receiver) | Sunlight:≤11,000 lx, incandescent lamp: ≤3,000 lx |
| Ambient temperature | -10 to 60 ℃, storage: -25 to 75 ℃ (no freezing or condensation) |
| Ambient humidity | 35 to 85 %RH, storage: 35 to 85 %RH (no freezing or condensation) |
| Protection rating | IP67 |
| Connection | connector type |
| Cable spec. | M12 connector 4PIN |
| Material | Case: Brass, Ni-plate |
| Sensing part: PC lens |
EN
