EN
F42 sensor ultrasonics 500mm 2m 4m
It can detect filling liquid levels ranging from a few millimeters to 8 meters. The ultrasonic sensor comes with one or two switch outputs for high and low liquid level control, or analog outputs of 0-10V and 4-20mA. In addition, there is an ultrasonic sensor made of chemical resistant PTFE material
- Overview
- Related Products
| Product model | UCX50-F42-D6-H5 | UCX200-F42-D6-H5 | UCX400-F42-D6-H5 | ||
| UCX50-F42-D7-H5 | UCX200-F42-D7-H5 | ||||
| UCX50-F42S-D6-H5 | UCX200-F42S-D6-H5 | UCX400-F42-D7-H5 | |||
| UCX50-F42S-D7-H5 | UCX200-F42S-D7-H5 | ||||
| Detection range | 50..500mm | 80..2000mm | 200...4000mm | ||
| Non-detection zone | 0...50mm | 0...80mm | 0mm ..200mm | ||
| Transducer frequency | About 380KHz | About 180KHz | 85KHZ | ||
| response time | 21ms | About 65ms | About 145ms | ||
| Standard target version | ≤7Hz | ≤ 2.5Hz | ≤ 1Hz | ||
| type of output | D6：2 switch outputs PNP, NO/NC, programmable | ||||
| D7：2 switch outputs NPN, NO/NC, programmable | |||||
| Rated working current | 200mA Passage/overload protection | ||||
| accuracy of rated working | ≤ 0.5% | ||||
| working voltage | 10-30V DC ripple 10% | ||||
| Range adjustment | Adjust the farthest and nearest range through the adjusting line | ||||
| Degree of protection | IP65 | ||||
| Connection mode | Connector plug M12 x 1 , 5-pin/2m PVC cable | ||||
| LED yellow light | The yellow light of the switch status indicator flashes. The target is detected under the set status | ||||
| LED red light | The red light is always on: error Red light flashing: no target is detected in the set state |
||||
