| Product model | UBX50-GM1875-D4-H5 | UBX100-GM1875-D4- H5 | UBX50-GM1875-D6-H5 | UBX100-GM1875-D6- H5 |
| UBX50-GM1875-D5-H5 | UBX100-GM1875-D5- H5 | UBX50-GM1875-D7-H5 | UBX100-GM1875-D7- H5 |
| Detection range | 50...500mm | 70...1000mm | 50...500mm | 70...1000mm |
| Non-detection zone | 0mm ..50mm | 0mm ..70mm | 0mm ..50mm | 0mm ..70mm |
| Transducer frequency | About 380KHz | About 205KHZ | About 380KHz | About 205KHZ |
| response time | About 50ms | About 150ms | About 50ms | About 150ms |
| Standard target version | ≤ 13Hz | ≤ 4Hz | ≤ 13Hz | ≤ 4Hz |
| type of output | D4 :NPN normally open/normally closed D6：2 switch outputs PNP, NO/NC,
programmable |
D5：PNP normally open/normally closed D7：2 switch outputs NPN, NO/NC,
programmable |
| working voltage | 10-30V DC ripple 10% |
| Rated working current | 200mA Passage/overload protection | 2 x 100 mA , short-circuit/overload
protected |
| accuracy of rated working | ≤ 1% |
| Range adjustment | Adjust the farthest and nearest range through the adjusting line |
| Degree of protection | IP65 |
| Connection mode | Connector plug M12 x 1 , 5-pin/2m PVC cable |
| LED yellow light | The yellow light of the switch status indicator flashes. The target is
detected under the set status |
| LED red light | The red light is always on: error
Red light flashing: no target is detected in the set state |
EN
