EN
SN:2M 4M 6M 8M Button type ultrasonic sensor
Ultrasonic sensors also have a wide range of applications in the field of level detection. For example, in storage tanks, storage locations, transportation vehicles, etc., ultrasonic sensors are used to detect information such as the height, quantity, and location of items
- Overview
- Related Products
| Product model | UBX200-GM30-B4-H5 | UBX400-GM30-B4-H5 | UBX600-GM30-B4-H5 | UBX800-GM30-B4-H5 | |
| UBX200-GM30-B5-H5 | UBX400-GM30-B5-H5 | UBX600-GM30-B5-H5 | UBX800-GM30-B5-H5 | ||
| UBX200-GM30-B6-H5 | UBX400-GM30-B6-H5 | UBX600-GM30-B6-H5 | UBX800-GM30-B6-H5 | ||
| UBX200-GM30-B7-H5 | UBX400-GM30-B7-H5 | UBX600-GM30-B7-H5 | UBX800-GM30-B7-H5 | ||
| UBX200-GM30-BI-H5 | UBX400-GM30-BI-H5 | UBX600-GM30-BI-H5 | UBX800-GM30-BI-H5 | ||
| UBX200-GM30-BU-H5 | UBX400-GM30-BU-H5 | UBX600-GM30-BU-H5 | UBX800-GM30-BU-H5 | ||
| Detection range |
80 ... 2000 mm | 200 ... 4000 mm | 350 ... 6000 mm | 400 ... 8000 mm | |
| Non-detection zone |
0 ... 80 mm | 0 ... 200 mm | 0 ... 350 mm | 0 ... 400 mm | |
| Transducer frequency |
approx. 180 kHz | approx. 85 kHz | About 65KHz | About 65KHz | |
| response time | About 195 ms | 145 ms minimum 440 ms factory setting |
285 ms minimum 850 ms factory setting |
285 ms minimum 850 ms factory setting |
|
| Standard target version | max. 30 Hz | max. 13 Hz | max. 7 Hz | max. 7 Hz | |
| type of output | B4 :NPN normally open/normally closed B6：2 switch outputs PNP, NO/NC, | ||||
| B5：PNP normally open/normally closed B7：2 switch outputs NPN, NO/NC, | |||||
| BI:4-2mA BU:0-10V/0-5V | |||||
| working voltage |
10-30V DC ripple 10% | ||||
| Rated working current |
200mA Passage/overload protection | 2 x 100 mA , short- circuit/overload protected |
|||
| Repetition accuracy of |
≤ 0.5% | ≤ 0.1% | |||
| Range adjustment |
Adjust the farthest and nearest range through the adjusting line | ||||
| Degree of protection |
IP65 | ||||
| Connection mode | Connector plug M12 x 1 , 5-pin/2m PVC cable | ||||
| LED yellow light | The yellow light of the switch status indicator flashes. The target is detected under the set status | ||||
| LED red light | The red light is always on: error Red light flashing: no target is detected in the set state |
||||
